TPC-15W/TPC-20W/TPC-25W

Wheel type CPT vehicle uses hydraulic transmission system to penetrate, anchor, level and lift car body, etc.

The hydraulic system's oil is supplied by a large flow and high-pressure gear pump with an advanced directioncontrolling combination multi-way valve which is installed in the console center. Each a hydraulic valve controls one circuit. On the right of multi-way valve, the relief valve is installed to control the oil pressure.

The operation panel has two layers. The upper is the main control circuit while the lower is oil cylinder control circuit. On the upper layer there are three control rods: the left one to control penetration system; the middle one to control the anchor system; the right one to control the hydraulic props. The lower four rods is to control oil cylinder.

TECHNICAL PARAMETERS

Engine type: Diesel CZ2100

Max speed: 40KM/h

Max force: 150kN, 200kN, 250kN

Drive: Diesel Engine, Electric starting

Oil pressure: 10 Mpa

Penetration speed: 1.2±0.3m/min

Dimension(m): 3.1×1.6×1.63

Weight: 3000Kg

Operation part

TPCL-001A Operation system 1set

TPCL-001C Vehicle (20t)  1

Penetration part

TPCL-002A Penetration cylinder 1set

TPCL-002B Penetration rod(ø40) 50

Anchoring part

TPCL-003A Hydraulic anchor machine 1set

TPCL-003B Ground anchor 6sets

TPCL-003C Anchor fixing beam 2

TPCL-003D Wedge key on anchor tip 10

TPCL-003E U-shaped heave device 1set

Accessories

TPCL-004A Fixing block 2

TPCL-004B Reducer union 1

TPCL-004C Guide sleeve(ø40) 1set

TPCL-004D Tool 1set

TPCL-004E Gasket 1set

TPCL-004F 8 core cable 80m